This is the Hunter 99121 remote that came with Hunter ceiling fans.
How to confirm the fit
Find the FCC ID on the back of your old remote or inside its battery compartment. It should match IN2TX42. If your remote shows a different FCC ID, this remote will not work with your fan's receiver.
Specifications
- Radio frequency (RF): 434 MHz
- FCC ID: IN2TX42
- Battery: 1 CR2032 (not included)
Good to Know
- Works only with fans that have a Hunter receiver that pairs with IN2TX42 remotes (434 MHz).
- It is not a universal remote.
Setup / Pairing
Safe Exit lighting depends on the bulb: on dimmable/incandescent bulbs the light stays at 50% for about 15 seconds then off; with CFL bulbs the light stays at 100% for 30 seconds then off.
- Install a CR2032 battery, positive (+) side up (the battery door is held by a small Phillips screw).
- Turn on the power to the fan.
- Within three minutes of restoring power, press and hold Fan Off and High together for at least four seconds. The remote is now paired.
- For more than one fan, repeat for each fan.
Safety: turn off power at the circuit breaker before opening the fan canopy or touching the receiver.
What's in the Box
- 1 Hunter 99121 remote
- Battery not included
Compatible Models
- Hunter 99121 (FCC ID IN2TX42)
- Other part numbers: K0472-01
Before ordering, check the model or part number printed on your old remote (usually on the back or inside the battery compartment) and compare it to this list.
