Description
The Anderic UC9051T-UC7067GMRX kit is a substitute for the UC9050TB4. It is a wireless wall control and ceiling fan receiver kit (UC9051T wireless wall remote and UC7067GMRX receiver).
Specifications
- Kit: Anderic UC9051T-UC7067GMRX
- Radio frequency (RF): 303.875 MHz
- Battery: 1 A23 (not included)
Good to Know
- It comes with its own receiver and remote; the existing receiver and remote are not used.
- The UC9050TB4 is a wired wall control; this wall control is battery-powered and wireless, and mounts with a face plate.
- For 3-speed AC ceiling fans; the receiver is wired into the fan canopy.
- Key names, layout and the look of the case may differ from the original. Compare your original's buttons before ordering.
Setup / Pairing
- Turn off power at the circuit breaker or fuse box.
- Remove the fan canopy and disconnect the existing wiring between the fan and the house supply, including any old receiver.
- Connect the receiver with the supplied wire nuts: receiver black (AC IN L) to the house black wire, receiver white (AC IN N) to the house white wire, receiver white (TO MOTOR N) to the fan white wire, receiver black (TO MOTOR L) to the fan black wire and receiver blue (FOR LIGHT) to the fan down-light wire and the receiver up-light wire to the fan up-light wire; connect the fan green wire to the bare house ground.
- Lay the antenna wire on top of the receiver, place the receiver in the mounting bracket, push the wires into the box and reinstall the canopy.
- Unsnap the wall control face plate using the notch at the bottom and insert an A23 battery.
- Set the wall control dip switches to match the receiver's dip switches, refit the face plate, restore power and test.
What's in the Box
- 1 remote and 1 receiver
- Battery not included
Compatible Models
- UC9050TB4
Before ordering, check the model or part number printed on your old remote (usually on the back or inside the battery compartment) and compare it to this list.
Specifications
Product help/documentation (if applicable): User Guide
Features:
- Replaces your UC9050TB4 with a wireless wall control and ceiling fan receiver kit (UC9051T wireless wall remote and UC7067GMRX receiver). High, Medium and Low fan speeds and fan off.
- Turn off power at the circuit breaker or fuse box. Remove the fan canopy and disconnect the existing wiring between the fan and the house supply, including any old receiver.
- High, Medium and Low fan speeds and fan off.
- Up and down light on/off and dimming. Reverse, if the fan supports it.
- Takes 1 23A battery, not included.
Part/Model Number: CHQ9050TB4 / UC9050TB4
Power Information: 1 A23 Required, Not Included
FCC ID (if applicable): CHQ9050TB4
Frequency (if applicable): 303.875 MHz
Compatible with models (if applicable): UC9050TB4, KUJCE10605, TR269A, KUJCE10606
Compatible Substitutes and Related Products
- 5 stars: 25 (83%)
- 4 stars: 4 (13%)
- 3 stars: 1 (3%)
- 2 stars: 0 (0%)
- 1 star: 0 (0%)
Perfect hard to find switch. Got here right on schedule .
Easy to install, more reliable than a remote.
Item arrived very fast, it was as described, and worked right away as it should. Happy with my purchase
Hi Andy, we're thrilled to hear you're happy with your purchase! Thanks for choosing Anderic, and feel free to reach out if you need any assistance in the future.
The control worked flawlessly. I had a lot of great help from the customer service rep which I greatly appreciate.
Thank you for leaving a review! We’re so glad to hear everything worked out and that one of our customer service representatives was able to provide great support. We’re proud of our team and love knowing their efforts made a positive difference. Thanks again for choosing Anderic!
No problem with the switch make sure that you know how to set your pins for it to work properly, smooth operation just wish that the round button to turn the lights on which is made to glow in the dark, actually had its own light source to see it in the dark.
Perfect replacement for a switch no longer made by the fan manufacturer.
Switch Light and Fan Control works as expected. Not very difficult to install. Happy with purchase.
Happy to know everything’s working just the way you hoped! Thanks for sharing your experience and for trusting Anderic!!
About 10$ more expensive than Amazon. Didn't check before I purchased. The fan wall switch worked fine and was easy to install.
Happy about the service but to no fault of yours the receiver won’t respond So thank you and we’re going to save it until we get another fan and get a reciever then
This fan wall controller was functionally a perfect substitute for the Craftsman UC7077T that is no longer made. I had tried two other products that didn’t work, one that I bought from a website that claimed to be a a UC7077T and wasn’t, and the Craftsman advertised replacement for UC7077T, neither worked for my fan/light, which uses a dip switch. Also the product was shipped promptly by Anderic.
Power outage shorted out monte Carlo fan control receiver. 3 speed fan with reverse and up and down lights. Tried other receivers and none worked but this one worked correctly and with three different controllers I had on hand. Two wireless wall controls and one remote.
Fast shipping made the purchase even better.
So far so good for a week! Replaced a Regent fan control that lasted more than 15 years. Hope it lasts a few years! Thanks for having a replacement!
This customer rated this item 5 out of 5 stars (left no comment).
Perfect replacement and easy to install
exactly what I ordered at a much better price than "you know who". Thanks
p.s. I'm not sure how you solve this, but I was very reluctant to order from you as I've been scammed online before
This customer rated this item 5 out of 5 stars (left no comment).
it worked great
Perfect fast shipping will us again for sure
easy to install, thought they had function for up lights, but they did not. we just turn them off and the uplights go off.
This customer rated this item 5 out of 5 stars (left no comment).
Perfect replacement. Shipping was faster than expected! Price was extremely reasonable. Will look forward to doing business again with Dan’s Electronics.
This customer rated this item 5 out of 5 stars (left no comment).
All is good.
Price very competitively and works as advertised.
Had a issue getting the ones I wanted, the wired and non wired use the same part number, was a bit of a mix up when ordered,
Worked great
Perfect replacement! Restored the full functionality of my fan!
Worked right out of the box. Just what we needed. Wired, so no battery needed.