Description
The Anderic UC9051T-UC7067GMRX is a substitute kit for the KUJCE10605: a UC9051T wireless wall controller and a UC7067GMRX receiver on 304 MHz.
Specifications
- Kit: Anderic UC9051T-UC7067GMRX
- Radio frequency (RF): 304.25 MHz
- Battery: 1 A23 (not included)
- Upper and lower lights (on/off and dimming) and fan speeds (high, medium, low, off)
Good to Know
- It comes with its own receiver; your existing remote does not pair with it, and the receiver must be installed in the fan canopy.
- It is a wall controller, not a hand-held remote.
- Reverse works only on fans built with reverse.
Setup / Pairing
Installing the UC7067GMRX receiver
WARNING: High voltage. Household electrical power can cause serious injury or death. Disconnect power to the ceiling fan by removing the fuse or switching off the circuit breaker.
- Remove the ceiling fan canopy from the mounting bracket.
- Disconnect the existing wiring between the ceiling fan and the supply at the junction box. If you are replacing a receiver, disconnect all of its wires.
- Lay the black antenna wire on top of the receiver and put the receiver in the mounting bracket.
- Make these connections with the supplied wire nuts: black receiver wire (AC IN L) to black supply wire; white receiver wire (AC IN N) to white supply wire; white receiver wire (TO MOTOR N) to white fan wire; black receiver wire (TO MOTOR L) to black fan wire; blue receiver wire (FOR DOWN LIGHT) to blue fan wire; red receiver wire (FOR UPPER LIGHT) to red fan wire.
- Push all connected wires up into the junction box.
- Reinstall the canopy on the mounting bracket.
- Restore the electrical power.
Setting the codes
- Before reinstalling the fan housing or canopy, note the dip switch pattern on the UC7067GMRX receiver (or set it to the pattern you want).
- On the remote, remove the battery cover and slide the 4 dip switches up or down. The factory setting is all switches up; we recommend using a different combination.
- Set the switches on the remote to EXACTLY match the switches on the UC7067GMRX receiver. The remote and receiver will only work together when both patterns are the same.
- Replace the battery cover, restore power and test the fan and light.
What's in the Box
- 1 remote and 1 receiver
- Battery not included
Compatible Models
- Listed for the KUJCE10605. Works on 3-speed and 4-speed pull-chain ceiling fans
Before ordering, check the model or part number printed on your old remote (usually on the back or inside the battery compartment) and compare it to this list.
Specifications
Product help/documentation (if applicable): Installation Instructions
Features:
- Made for your KUJCE10605. Wall controller and UC7067GMRX receiver kit.
- Install the UC7067GMRX receiver with the power off, then set the remote's 4 dip switches to match it; step-by-step instructions are in the description.
- Wireless wall controller for upper and lower lights, fan speeds and reverse.
- It replaces the receiver and is a wall controller, not a hand-held remote. Your old remote does not work with the new receiver.
- Wall controller takes 1 A23 battery, not included.
Part/Model Number: KUJCE10605 / KUJCE10605
Power Information: 1 A23 Required, Not Included
FCC ID (if applicable): KUJCE10605
Frequency (if applicable): 304.25 MHz
Compatible with models (if applicable): KUJCE10605, TR269A, KUJCE10606, UC9050TB4
Compatible Substitutes and Related Products
- 5 stars: 25 (83%)
- 4 stars: 4 (13%)
- 3 stars: 1 (3%)
- 2 stars: 0 (0%)
- 1 star: 0 (0%)
Perfect hard to find switch. Got here right on schedule .
Easy to install, more reliable than a remote.
Item arrived very fast, it was as described, and worked right away as it should. Happy with my purchase
Hi Andy, we're thrilled to hear you're happy with your purchase! Thanks for choosing Anderic, and feel free to reach out if you need any assistance in the future.
The control worked flawlessly. I had a lot of great help from the customer service rep which I greatly appreciate.
Thank you for leaving a review! We’re so glad to hear everything worked out and that one of our customer service representatives was able to provide great support. We’re proud of our team and love knowing their efforts made a positive difference. Thanks again for choosing Anderic!
No problem with the switch make sure that you know how to set your pins for it to work properly, smooth operation just wish that the round button to turn the lights on which is made to glow in the dark, actually had its own light source to see it in the dark.
Perfect replacement for a switch no longer made by the fan manufacturer.
Switch Light and Fan Control works as expected. Not very difficult to install. Happy with purchase.
Happy to know everything’s working just the way you hoped! Thanks for sharing your experience and for trusting Anderic!!
About 10$ more expensive than Amazon. Didn't check before I purchased. The fan wall switch worked fine and was easy to install.
Happy about the service but to no fault of yours the receiver won’t respond So thank you and we’re going to save it until we get another fan and get a reciever then
This fan wall controller was functionally a perfect substitute for the Craftsman UC7077T that is no longer made. I had tried two other products that didn’t work, one that I bought from a website that claimed to be a a UC7077T and wasn’t, and the Craftsman advertised replacement for UC7077T, neither worked for my fan/light, which uses a dip switch. Also the product was shipped promptly by Anderic.
Power outage shorted out monte Carlo fan control receiver. 3 speed fan with reverse and up and down lights. Tried other receivers and none worked but this one worked correctly and with three different controllers I had on hand. Two wireless wall controls and one remote.
Fast shipping made the purchase even better.
So far so good for a week! Replaced a Regent fan control that lasted more than 15 years. Hope it lasts a few years! Thanks for having a replacement!
This customer rated this item 5 out of 5 stars (left no comment).
Perfect replacement and easy to install
exactly what I ordered at a much better price than "you know who". Thanks
p.s. I'm not sure how you solve this, but I was very reluctant to order from you as I've been scammed online before
This customer rated this item 5 out of 5 stars (left no comment).
it worked great
Perfect fast shipping will us again for sure
easy to install, thought they had function for up lights, but they did not. we just turn them off and the uplights go off.
This customer rated this item 5 out of 5 stars (left no comment).
Perfect replacement. Shipping was faster than expected! Price was extremely reasonable. Will look forward to doing business again with Dan’s Electronics.
This customer rated this item 5 out of 5 stars (left no comment).
All is good.
Price very competitively and works as advertised.
Had a issue getting the ones I wanted, the wired and non wired use the same part number, was a bit of a mix up when ordered,
Worked great
Perfect replacement! Restored the full functionality of my fan!
Worked right out of the box. Just what we needed. Wired, so no battery needed.