Anderic Substitute for Epson 164880600 Projector Remote Control [RR3720]

The Anderic RR3720 is a substitute for the Epson 164880600 remote. It is a universal projector remote with code library and learning. It works with Epson projectors such as PowerLite107, PowerLite108 and PowerLite109W.

Specifications

• Shipped remote: Anderic RR3720
• Infrared (IR); point it at the device
• Batteries: 2 AAA (not included)

Good to Know

• Not pre-programmed: needs a 4-digit code, code search or learning
• Key layout and labels differ from the original remote; use the learning function to add any model-specific keys
• IR only: line of sight to the projector is required

Setup / Pairing

1. Turn on the projector.
2. Press and hold Mute and the Down key for about 3 seconds until the indicator light stays on, then release.
3. Enter the 4-digit code for your projector brand from the code list; the light goes off if the code is valid.
4. Check that most keys work; if not, repeat with another code for the brand, or hold Power during code search until the projector responds.

Troubleshooting

• If the indicator blinks three times after you enter a code, the code was not accepted; enter it again or try another code for your brand.
• If no key is pressed for 30 seconds, the remote leaves programming mode; start again.
• When learning, hold the two remotes 1 to 2 inches apart with the IR ends pointing at each other. Three flashes mean the key was not learned; start that key again.
• To clear learned keys, hold Mute and OFF for about 3 seconds until the light flashes twice. To reset, hold Mute and Reset the same way.

What's in the Box

• 1 Anderic RR3720 universal projector remote
• Batteries not included

Compatible Models

• Epson 164880600
• Works with many Epson projectors, including models starting with POWERLITE12 and POWERLITE10.

Before ordering, check the model or part number printed on your old remote (usually on the back or inside the battery compartment) and compare it to the full compatible models list.